err Moves less than minimum length G02

Home › Forums › TinyG › TinyG Support › err Moves less than minimum length G02

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 26, 2016 at 3:33 pm #9495
    dwhughes08
    Member

    Updated system from gshield to TinyG. New to the numerous settings. Old files successful on gshield coming to a halt with: err Moves less than minimum length G02. Test with square seems to work. Spooling file with Coolterm. The following is the last few lines before error:

    posx:50.593,posy:21.971
    posx:49.376,posy:22.056
    posx:48.159,posy:22.140
    posx:46.942,posy:22.224
    qr:31, qi:0, qo:1
    posx:45.706,posy:22.340
    posx:44.495,posy:22.457
    posx:43.287,posy:22.574,vel:290.31
    posx:42.802,posy:22.621,vel:0.00,stat:3
    qr:32, qi:0, qo:1
    tinyg [mm] err: Move less than minimum length: G02

    Some of the settings from $$
    [fb] firmware build 440.20
    [fv] firmware version 0.97
    [hp] hardware platform 1.00
    [hv] hardware version 8.00
    [id] TinyG ID 3X3566-WQQ

    March 27, 2016 at 2:29 pm #9496
    cmcgrath5035
    Moderator

    Here is a link with status codes enumerated:

    Is this really an error (e.g. half way thru the job) or a ‘warning’ at end of job?
    Very (very) few folks watch warnings coming back unless something really bad happens (such as stop in middle of job).

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.