E-Stop

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1577
    smounic
    Member

    I just got the grblShield up and going with my CNC mill. It works well so far, but I’m looking to package it up to make it usable for my milling activities. As far as I’m aware, grbl does not have a provision for an e-stop button. Is this correct? Do you have any suggestions on adding one? I can add it to to the software and wire it to a pin if need be … Thanks.

    #1578
    alden
    Member

    Sonny Jeon (Chamnit) is working on connecting an eStop to grbl. The challenge is doing this right with deceleration. I could ping him and find out how he’s done it, and how far along he is. BTW – you should grab his fork for your work. He’s done a really nice job on the cornering algorithm and a few other improvements.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.