Drilling – Canned Cycles

Home › Forums › TinyG › TinyG Support › Drilling – Canned Cycles

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 26, 2015 at 1:08 am #7464
    thecableguy
    Member

    Good day,

    I generated a G-code file containing some hole drilling and profile machining operations. It doesn’t look like the TinyG is recognizing the G81 or G83 canned cycles I’ve tried. The drill paths are missing in Chilipeppr and when I run the file on the CNC the entire block containing the canned cycle codes is skipped. I posted to the Chilipeppr forum as well just in case it’s an issue there, or possibly an issue with my G-code. I don’t see a spot here to upload the file otherwise I would.

    Thanks in advance,

    Brian

    February 26, 2015 at 7:25 am #7467
    cmcgrath5035
    Moderator

    Same answer here , see:

    G81 and canned cycles not supported, yet anyway

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.