Configure both Normally Closed (NC) and Normally Open (NO) switches

Home › Forums › TinyG › TinyG Support › Configure both Normally Closed (NC) and Normally Open (NO) switches

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 19, 2014 at 3:29 am #6193
    O1iv3r
    Member

    Does anyone know if there is currently a way to configure TinyG to work with both Normally Closed and Normally Open switches on different inputs simultaneously. I have just setup mechanical NC switches at the x-min and y-min axis of my ShapeOko as well as aHall Effect sensor on the z-max which appears like a NO switch to TinyG.

    *I first posted this as a feature request, but thought I’d also check here in case it is indeed possible to configure switches on a per input basis opposed to only globally.

    June 19, 2014 at 7:11 am #6194
    cmcgrath5035
    Moderator

    Yours is the first question I have seen on this topic, I’d guess “no” with the current FW, since there is just a single NO/NC setting parameter ($st)in the config file.

    June 19, 2014 at 2:17 pm #6197
    O1iv3r
    Member

    It seems there is a page on the github wiki, last edited back in September, which talks about refactoring the way switches are handled to better accommodate different switch types simultaneously, , which is the only place I have seen this issue identified and discussed. No idea if a solution is in the works or any additional functionality has been implemented into the edge/dev builds.

    • This reply was modified 10 years, 5 months ago by O1iv3r.
    June 19, 2014 at 2:38 pm #6199
    O1iv3r
    Member

    It looks like the last edited edge build still only has a global setting for configuring switch types -> (feature-410.06-base)

    • This reply was modified 10 years, 5 months ago by O1iv3r.
  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.