Found a simple solution for uploading grbl to Ardunio

Home › Forums › gShield › grblShield Support › Found a simple solution for uploading grbl to Ardunio

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 18, 2012 at 10:05 pm #3565
    skinnytod
    Member

    Hi – this may be old news but thought I would post here in case anyone is trying to upload grbl to their Arduino. I found a simple solution using Xloader

    I did this on a Mac running Windows XP through VMWare. I installed the Arduino IDE to make sure I could communicate with the board (an UNO) and had to screw around a bit setting up the COM port (esp baud rate) – the instructions on the Arduino site are helpful. After that, it was just a matter of launching Xloader, selecting the .hex file and pressing the button to upload.

    Afterwards I ran ZTerm (terminal app) on my Mac and was able to get the confirmation msg from grbl and a dump of the setting.

    Really painless. Yay!

    • This topic was modified 12 years, 1 month ago by skinnytod.
    October 19, 2012 at 7:57 am #3567
    alden
    Member

    Thanks for the tip. Xloader really is a good way to do this.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.