SpDir flashing after G Code file was started from Chilipeppr

Home › Forums › TinyG › TinyG Support › SpDir flashing after G Code file was started from Chilipeppr

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 30, 2016 at 5:40 pm #10147
    crchisholm
    Member

    Curious, usually that flashing is accociated with a stop being triggered. If that were the case, and if the cause of the triggering has not been corrected before resetting, could that cause behavior like you describe?

    • This reply was modified 8 years, 3 months ago by crchisholm.
    • This reply was modified 8 years, 3 months ago by crchisholm.
    December 30, 2016 at 5:42 pm #10149
    cmcgrath5035
    Moderator

    How long have you had your tinyG?
    Do you use it frequently?

    You could be experiencing this issue

    if you tinyG had been sitting on the shelf for a while.
    Those with suspect units usually hit the flashing SpnDir fairly quickly (one or two runs).

    Are you sure the boot up response you are seeing is from tinyG, not SPJS?

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.