greyhound716

Forum Replies Created

Viewing 61 post (of 61 total)
  • Author
    Posts
  • in reply to: Odd behaviors – only X axis works #1513
    greyhound716
    Member

    Thanks for the quick response!

    When I reset and do the g0x100y100z100, I get another ok prompt immediately, however no motor lights go on, etc. Hitting ? it tells me the position is still x0y0z0. I reset again, and for each of the instructions you gave, the result is the same – no motor lights, and the position doesn’t change.

    The trimpots are freely moving – I don’t think I even touched them until I start to diagnose the problem, and I didn’t try to torque them past their limit stops.

    Given that the internal position doesn’t appear to change, I’m inclined to think it’s a software/settings issue, but I’m at a loss on how to diagnose it.

    BTW, if I use g1, the motor light comes on, but only for x, and the x position changes with ?. I did not try g1 with the command sequence you gave me however.

    One last bit of data… If I say g0x100y100z100 and then enter g1, the X motor kicks in and changes position. No other axis does anything.
    -Matt

Viewing 61 post (of 61 total)