LED Readouts

Home › Forums › TinyG › TinyG Support › LED Readouts

Tagged: , ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • June 9, 2016 at 5:07 pm #9782
    suitlessintx
    Member

    I have a Creation Station that I am having problems with. I have never had it running. When I power it up the Blue LED D2 comes on and stays solid blue. The D6 SpDir LED blinks red 12 times and goes off and then the D7 PWM comes on Red and stays on. I think it has to do with the spindle. I was hoping to find out if this indicates a problem and how to fix it. If I could find out how to troubleshoot this issue it would get me a little farther alone and getting this machine running.

    June 9, 2016 at 6:43 pm #9783
    cmcgrath5035
    Moderator

    Flashing SpinDir means the bootloader is running and accepting connects from avrdude. After the delay, it boots tinyG FW.

    If yet set parameter $p1pof=0.0,
    the PWM led will go out.
    If your want to know more about spindle setup, have a look here

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.