Incremental position output

Home › Forums › TinyG › TinyG Support › Incremental position output

Viewing 1 post (of 1 total)
  • Author
    Posts
  • April 14, 2016 at 6:47 pm #9557
    jimt
    Member

    Is there a way to setup a GCode command such that in moving from point A to point B an output (IO) can be triggered at a specified increment of the move? This is called pegging on some motion controller.

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.