wiring probe

Home › Forums › TinyG › TinyG Support › wiring probe

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 13, 2015 at 3:47 am #9134
    alhaddar
    Member

    Hi

    I have tiyng v8
    how wiring probe on tiyng board

    thanks

    December 13, 2015 at 7:02 am #9135
    cmcgrath5035
    Moderator

    This wiki item

    is a comprehensive tutorial on how probing assists in leveling a PCB.

    Probe wiring: connect wire from tinyGV8 Xmin switch port to tool bit with clip lead or similar.
    Connect ground to surface to be probed.
    Shielded pair recommended.
    Ground shield drain wire to GND at tinyG as well.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.