Hardwire TinyG reset button?

Home › Forums › TinyG › TinyG Support › Hardwire TinyG reset button?

Tagged: 

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 11, 2015 at 7:15 pm #8217
    sraney
    Member

    I should have looked for this before building my case. Is there a way to connect an external button to the TinyG without ‘Soldering’ a set jumpers? Im not sure if one exists or I need to add it.

    The wiki’s ‘TinyG-Start’ board image looks to have a spot for a jumper, but the V8 board I have does not have the jumpers.. I think.

    TinyG Board

    and my board:

    My board

    August 11, 2015 at 7:30 pm #8218
    cmcgrath5035
    Moderator

    The schematic shows two nodes in addition to the switch.

    Likely just above the push-button, but you’ll ahve to solder in some pins

    August 11, 2015 at 7:43 pm #8221
    sraney
    Member

    Thanks. I see the two Solder-points. I was about to ask ask If I need to use a NC or OC across the jumper, but taking a quick peek at the schematic answered that question. Now I just need to figure out if I need to add an additional pull up to 3.3v or if the existing 56Kr (R6) on the schematic should deal with it.

    August 11, 2015 at 9:45 pm #8223
    cmcgrath5035
    Moderator

    I would say R6 is all you need.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.