Can't edit Tinyg config

This topic has 1 reply, 2 voices, and was last updated 11 years, 5 months ago by cmcgrath5035.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
April 28, 2015 at 11:22 pm #7672
zonyc
Member
Hello,

I recently purchased a tinyg board for my ox cnc. The board is able to connected to my PC via USB using chilipeppr, however, I am unable to edit the config for things like motor direction, steps etc.

When I click the settings button, I get this page:

http://i.imgur.com/Dno8pcNl.png

I have also tried to update the firmware using the tinyg updater but also get an error there which says “verify failed!” before it even begins to update the board.

Any help would be greatly appreciated.

Thanks
- This topic was modified 11 years, 5 months ago by zonyc.
- This topic was modified 11 years, 5 months ago by zonyc.
April 29, 2015 at 9:14 am #7677
cmcgrath5035
Moderator
Be aware that Chilipeppr also has a forum like interface at
Info available either location.

In this case, you will find this issue resolved over last night – an piece of code-in-development was inadvertently turned on.
Refresh your CP browser tab, the older congigtinyG wizard should load for you.

The tinyG updater app is having difficulty on some platforms(OSs).
The older avrdude method still should work:
Adding the -e option, per
recommended
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Copyright Synthetos.com