I have max velocity set to 250 in/min on both my x and Y axis. When you do a G0 X5 or G0 Y5 the velocity is never reported higher than 250 as expected. But when its an X AND Y movement it reports higher than 250 (into the 300’s) (see below)
Is that normal and its the “calculated” angular velocity or is this a bug.. (running master branch 370.08 firmware)
[xvm] velocity maximum 250.000 in/min
tinyg [inch] ok>
[yvm] velocity maximum 250.000 in/min
tinyg [inch] ok>
tinyg [inch] ok>
posx:6.000,posy:6.000,vel:0.401,stat:5
posx:5.981,posy:5.981,vel:44.194
posx:5.862,posy:5.862,vel:168.459
posx:5.580,posy:5.580,vel:300.540
posx:5.193,posy:5.193,vel:352.652
posx:4.778,posy:4.778,vel:353.553
posx:4.362,posy:4.362
posx:3.967,posy:3.967
posx:3.551,posy:3.551
posx:3.156,posy:3.156
posx:2.740,posy:2.740
posx:2.324,posy:2.324
posx:1.929,posy:1.929
posx:1.513,posy:1.513
posx:1.098,posy:1.098
posx:0.706,posy:0.706,vel:347.140
posx:0.336,posy:0.336,vel:280.498
posx:0.094,posy:0.094,vel:137.192
posx:0.009,posy:0.009,vel:28.962
qr:24
posx:0.000,posy:0.000,vel:0.000,stat:3