TinyG port to Xplained board?

Home › Forums › TinyG › TinyG Support › TinyG port to Xplained board?

Tagged: 

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • June 9, 2013 at 3:22 pm #4171
    JerryB123
    Member

    Hello,

    Is there a port of TinyG that will run on an xMega-A3BU Xplianed board?

    I already have stepper drivers and need more than 2.5 amps each for a couple of my steppers, so the Synthetos TinyG board does not quite fit my needs, but I am intrigued by the possibilities of using TinyG (I have tried GRBL, but like the advanced acceleration profile that TingY supports). It seems like the above mentioned Xplained board could be a great platform for hosting TinyG (LCD for status display and extra flash memory for GCode storage) and could be a base for a stand-alone CNC machine as well as an advanced GRBL-like controller.

    Thank you.
    Jerry

    June 9, 2013 at 8:12 pm #4172
    alden
    Member

    Jerry,

    We have not ported TinyG to the Xplained board – or any other Xmega boards. We are about to release TinyG version 8 which has the step/dir/enable lines broken out. Also, we are porting to ARM which will open up a lot of other options.

    -Alden

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.