'HELP' says use $si=0

Home › Forums › TinyG › TinyG Support › 'HELP' says use $si=0

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 20, 2013 at 3:39 pm #3898
    n7qvu
    Member

    [fb] firmware build 370.05
    [fv] firmware version 0.95
    [hv] hardware version 7.00

    ‘HELP’ command says(also $h):
    Note: TinyG generates automatic status reports by default
    This can be disabled by entering $si=0

    When I try to enter $si=0, it comes back and indicates $si=50. Wiki says $si=50 is min value.
    I’m just trying to cut out most of the text dumps (useless to me) while my job is running.

    Does $si=0 work?

    Jerry

    March 20, 2013 at 6:37 pm #3901
    alden
    Member

    Another help issue. Will fix. To shut off status reports set status verbosity to zero $sv=0.  As of 0.95 Si only does the intervale and is not overloaded to also shut off reports.

    March 21, 2013 at 4:57 pm #3907
    n7qvu
    Member

    Fixed in 370.07

    Jerry

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.