Z axis not working

Home › Forums › gShield › grblShield Support › Z axis not working

Tagged: ,

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 30, 2012 at 2:21 am #1852
    Jtaylor
    Member

    X and y connections work great. Swapping motors – after shutting down confirms that the motors and wiring is good. Z axis pot has does not seem to work

    I purchased 2 grblshield ‘s so I will test the 2nd one tomorrow.

    Suggestions?

    January 30, 2012 at 2:23 am #1853
    Jtaylor
    Member

    Sorry, typing on an iPad sucks. My English really isn’t that bad

    January 30, 2012 at 11:24 am #1854
    Jtaylor
    Member

    I have tested the 2nd board and the z-axis is working just fine. As stated above, the z-axis pot on the 1st board does not seem to work.

    February 1, 2012 at 7:32 am #1855
    alden
    Member

    Sorry you are having problems with the Z axis pot, and thanks for diagnosing it. Please contact us off-list and we’ll exchange the board.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.