Homing prob with Y axis

Home › Forums › TinyG › TinyG Support › Homing prob with Y axis

Tagged: 

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 22, 2022 at 11:41 am #12124
    mristau
    Member

    Home finds Z and X minimums but Y does not seek its minimum.
    Thinking there might be a short in the Y switch I replaced but same.
    I can G92 and then send movement commands for ALL axis successfully.
    Any thoughts on what to check??

    January 22, 2022 at 4:25 pm #12125
    cmcgrath5035
    Moderator

    It could be an issue with your setup parameters.
    If you are using Chilippr or CoolTerm, head to the console and enter $$ and return to dump your parameters. Copy and paste them to a text file on you favorite Cloud drive (Gdrive, OneDrive, etc) and post a link to them back here.

    One item that looks strange in the above is that Homing Z should find the maximum, not minimum

    Also be sure to review this wiki item:https://github.com/synthetos/TinyG/wiki/Homing-and-Limits-Description-and-Operation

    January 24, 2022 at 12:55 pm #12126
    mristau
    Member

    Yep: Some power management settings got scrambled. Not sure how!

    January 24, 2022 at 6:06 pm #12127
    cmcgrath5035
    Moderator

    Good, you found it yourself and learned a bunch too, I bet.
    Good Luck

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.